The occurrence of river floods is strongly related to specific climatic conditions that favor extreme precipitation events leading to catchment saturation. Although the impact of precipitation and temperature patterns on river flows is a well discussed topic in hydrology, few studies have focused on the relationship between peak discharges and standard Climate Change Indices (ETCCDI) of precipitation and temperature, widely used in climate research. It is of interest to evaluate whether these indices are relevant for characterizing and predicting floods in the Alpine area. In this study, a correlation analysis of the ETCCDI indices annual time series and annual maximum flows is presented for the Piedmont Region, in North-Western Italy. Spearman’s rank correlation is used to determine which ETCCDI indices are temporally correlated with maximum discharges, allowing to hypothesize which climate drivers better explain the interannual variability of floods. Moreover, the influence of climate (decadal) variability on the tendency of annual maximum discharges is examined by spatially correlating temporal trends of climate indices with temporal trends of the discharge series in the last twenty years, calculated using the Theil-Sen slope estimator. Results highlight that, while extreme precipitation indices are highly correlated with extreme discharges at the annual timescale, with different indices that are consistent with catchment size, the decadal tendencies of extreme discharges may be better explained by the decadal tendencies of the total annual precipitation over the study area. This suggests that future projections of the annual precipitation available from climate models simulations, whose reliability is higher compared to precipitation extremes, may be used as covariates for non-stationary flood frequency analysis.
The runoff coefficient (RC) is widely used despite requiring to know the effective contributing area, which cannot be known a priori. In a previous work, we defined runoff length (RL), which is difficult to measure. This work aimed to define the minimum RL (mRL), a quantitative and easy proxy of RL, for use in a pilot study on biocrusts in the Tabernas Desert, Spain. We show that RC decreases according to a hyperbola when the contributing area increases, the independent variable being the length of the effective contributing area and its coefficient involving the effects of rainfall and surface features and antecedent conditions. We defined the mRL as the length of the effective contributing area making RC = 1, which is calculated regardless of the area. We studied mRL from three biocrust types and 1411 events clustered in seven categories. The mRL increased with rain volume and intensity, catchment area and slope, whereas plant cover and biocrust succession (with one exception) had a negative effect. Depending on the plot, mRL reached up 3.3–4.0 m on cyanobacterial biocrust, 2.2–7.5 m on the most widespread lichens, and 1.0–1.5 m on late-successional lichens. We discuss the relationships of mRL with other runoff-related parameters.
The paper deals with the determination of the discharge coefficient, effective head and newly the limit head in the Kindsvater-Shen formula for the determination of a relatively small discharge of clear water using a thin-plate weir with a triangular notch. The determination of the discharge coefficient, effective head and limit head is based on extensive experimental research and is verified by previous measurements by other authors. The experimental research was characterised by a large range of notch angles (from 5.25° to 91.17°), weir heights (from 0.00 m to 0.20 m), and water temperatures (from 15 °C to 45 °C), as well as a focus on relatively small heads (from 0.02 m to 0.18 m), which is where the strengths of the Kindsvater-Shen formula stand out. The experimental research supplemented existing knowledge about the overflow occurring with small heads and small weir notch angles. The newly determined dependencies in the Kindsvater-Shen formula extended its applicability to weirs with small notch angles and newly enabled the determination of the limit head, which restricts its applicability in the determination of small discharges.
The presence of gravel in soils modifies the porosity, pore connectivity and pore size distribution in the soil matrix as well as the soil matrix-gravel interfaces. The aim of the present study is to investigate the effect of relative volume of gravel in samples with gravel mass fractions of 5,10, 20 wt% and varying bulk densities (1.3, 1.45, 1.55, 1.60, 1.65 g cm–3) on (i) total porosity, field capacity, plant available water holding capacity, (ii) pore size distribution and (iii) thermal capacity of repacked sandy and silty soils. The focus of the study was to determine if laboratory measured soil water retention curves considering (i), (ii), and (iii) can be predicted by a gravel-based weighting factor, Rv, considering comprehensive significance tests. The sand-gravel mixtures show a decrease in the volume fractions of macropores and wide cores pores with an increase in the gravel contents, while the silt-gravel mixtures show an opposite trend. The root mean square errors (RMSE) between measured and fitted volumetric water contents, θ, between 0.006 and 0.0352 and between 0.002 and 0.004 for Rv-weighted volumetric water contents indicate that the van Genuchten-based Peters-Durner- Iden (PDI) model is appropriate for fitting. The soil water retention curves with mass gravel contents of up to 10 wt% for silt and 20 wt% for sand can be well predicted by weighting factors (relative volume of rock fragments) in the range between 0.045 and 0.058 for silt, and between 0.112 and 0.119 for sand. The results also indicate a decrease in the Rv-weighted saturated, cvsat, and dry, cvdry, thermal capacity with an increase in the gravel contents for both soils. Further investigations are needed to examine if and whether measured sand- and silt-gravel mixtures with mass gravel contents below 10 % or rather 20 % can be predicted with a weighting factor.
The interception process in subalpine Norway spruce stands plays an important role in the distribution of throughfall. The natural mountain spruce forest where our measurements of throughfall and gross precipitation were carried out, is located on the tree line at an elevation of 1,420 m a.s.l. in the Western Tatra Mountains (Slovakia, Central Europe). This paper presents an evaluation of the interception process in a natural mature spruce stand during the growing season from May to October in 2018–2020. We also analyzed the daily precipitation events within each growing season and assigned to them individual synoptic types. The amount and distribution of precipitation during the growing season plays an important role in the precipitation-interception process, which confirming the evaluation of individual synoptic situations. During the monitored growing seasons, precipitation was normal (2018), sub-normal (2019) and above-normal (2020) in comparison with long-term precipitation (1988–2017). We recorded the highest precipitation in the normal and above-normal precipitation years during the north-eastern cyclonic synoptic situation (NEc). During these two periods, interception showed the lowest values in the dripping zone at the crown periphery, while in the precipitation sub-normal period (2019), the lowest interception was reached by the canopy gap. In the central crown zone near the stem, interception reached the highest value in each growing season. In the evaluated vegetation periods, interception reached values in the range of 19.6–24.1% of gross precipitation total in the canopy gap, 8.3–22.2% in the dripping zone at the crown periphery and 45.7–51.6% in the central crown zone near the stem. These regimes are expected to change in the Western Tatra Mts., as they have been affected by windstorms and insect outbreaks in recent decades. Under disturbance regimes, changes in interception as well as vegetation, at least for some period of time, are unavoidable.
Microplastics (particles of plastics <5 mm) affect the physical, biological and hydrological properties of agricultural soil, as well as crop growth. We investigated the effect of the addition of three microplastics (high-density polyethylene (HDPE), polyvinyl chloride (PVC), and polystyrene (PS)) at a concentration of 5% (w/w) to a silty loam soil on selected soil properties and growth of radish (Raphanus sativus L. var. sativus). Changes in the soil properties and radish growth in three microplastic treatments were compared with the control. Soil properties (bulk density, hydraulic conductivity, sorptivity, water repellency) were estimated for each treatment at the beginning and at the end of the radish growing period (GP). The bulk density was significantly lower in the HDPE and PVC treatments compared to the control within the measurement at the beginning of the GP and in all microplastic treatments compared to the control at the end of the GP. The values of hydraulic conductivity and water sorptivity did not show significant differences between any treatments within the measurement at the beginning of GP, but they were significantly higher in the HDPE treatment compared to the control at the end of the GP. The growth of radish was characterized by the plant biomass and effective quantum yield of Photosystem II (Y (II)). We did not find a statistically significant difference in the total biomass of radish between any of the experimental treatments, maybe due to used concentration of microplastics. The mean value of Y (II) was significantly higher in all microplastic treatments compared to control only within the last measurement at the end of the GP. A statistically significant change of Y(II) in all microplastic treatments may indicate functional shift in soil properties; however, the measured values of the soil characteristics have not shown the significant changes (except for the bulk density values in all microplastic treatments and hydraulic conductivity together with sorptivity in HDPE treatment within the measurement at the end of GP).
Hillslope hydrology in agricultural landscapes is complex due to a variety of hydropedological processes and field management possibilities. The aim was to test if there are any differences in soil properties and water regime along the hillslope and to compare vineyard rows (vine) with inter-rows (grass) area for those properties. The study determined that there are significant differences in the contents of soil particle fractions, pH, and humus content along the slope (P < 0.0001), with lower confidence level in bulk density (P < 0.05). Differences between row and inter-row space were significant for the pH, humus, and silt content, but for sand and clay content, and bulk density differences were not determined. The study determined differences in soil water content among five slope positions (P < 0.0001), and between row and inter-row vineyard space (all with P < 0.05). Where in the upper slope positions (e. g., P1) soil water content was higher than on lower slope positions. Higher soil water content was observed at higher slope positions, associated with clay content. However, it can be concluded that the retention of moisture on the slope is more influenced by local-scale soil properties (primarily soil texture) and variability of the crop (row/inter-row) than the position on the slope.
The aim of the study was to assess the possibility of using the empirical formulas to determine the roughness coefficient in gravel-bed streams, the bed slopes of which range from 0.006 to 0.047. Another aim was to determine the impact of taking into account the conditions of non-uniform flow on the application of these formulas and to develop the correlation relationships between the roughness coefficient and water surface slope and also between the roughness coefficient and friction slope in order to estimate the roughness coefficient n in gravel-bed streams. The studies were conducted in eight measuring sections of streams located in the Kraków-Częstochowa Upland, southern Poland. The roughness coefficient n0 for these sections was calculated from the transformed Bernoulli equation based on the results of surveys and hydrometric measurements. The values of n0 were compared with the calculation results obtained from fourteen empirical formulas presenting the roughness coefficient as a function of slope. The Lacey, Riggs, Bray and Sauer formulas were found to provide an approximate estimate of the n value, while the best roughness coefficient estimation results were obtained using the Riggs formula. It was also found that taking into account the non-uniform flow and using the friction slope in the formulas instead of the bed slope or water surface slope did not improve the estimated values of the roughness coefficient using the tested formulas. It was shown that the lack of differences in the RMSE and MAE error values calculated for the developed correlation equations between the roughness coefficient and the friction slope or with the water surface slope also indicate no influence of the assumed friction slope or water surface slope on the value of the estimated roughness coefficient.
This study presents the results of 32 laboratory experiments on local scour at a single pile and a 1 × 4 pile group for both uniform and non-uniform sediments under clear water conditions. The present study aims to evaluate the effects of different sediment beds made up of mixtures of sand and gravel (four-bed configurations) in d50 (1–3.5 mm) and gradation (1.4–3) ranges on scour depth for different flow discharges and flow depths. Further, the findings of the experiments are deployed to describe the effects of pile spacing and flow conditions on the local pier scour for both uniform and non-uniform bed granulometries. In addition, this study addresses the performance of some existing scourdepth predictors. Also, the corresponding results are suitable for validating the numerical models in local pier scour prediction importantly with non-uniform sediments. In summary, the results show that effects of sediment gradation dampen with increasing flow shallowness. Furthermore, the maximum scour depth at pile groups generally increases as pile spacing decreases for uniform sediments, whereas the mentioned trend was not observed for non-uniform sediments for the same flow and sediment conditions. Moreover, the experimental results revealed that bed sediment gradation is a controlling factor in the pile’s scour. Thus, the existing scour depth predictions could be highly improved by considering sediment gradation in the predictions. Finally, the conclusions drawn from this study provide crucial evidence for the protection of bridge foundations not only at the front pile but also at rear piles.
CO2 injection is a well-known Enhanced Oil Recovery (EOR) technique that has been used for years to improve oil extraction from carbonate rock and other oil reservoirs. Optimal functioning of CO2 injection requires a thorough understanding of how this method affects the petrophysical properties of the rocks. We evaluated pore-scale changes in these properties, notably porosity and absolute permeability, following injection of CO2-saturated water in two coquina outcrop samples from the Morro do Chaves Formation in Brazil. The coquinas are close analogues of Presalt oil reservoirs off the coast of southern Brazil. The effects of carbonated water injection were evaluated using a series of experimental and numerical steps before and after coreflooding: cleaning, basic petrophysics, microtomography (microCT) imaging, nuclear magnetic resonance (NMR) analyses, and pore network modeling (PNM). Our study was motivated by an earlier experiment which did not show the development of a wormhole in the center of the sample, with a concomitant increase in permeability of the coquina as often noted in the literature. We instead observed a substantial decrease in the absolute permeability (between 71 and 77%), but with little effect on the porosity and no wormhole formation. While all tests were carried out on both samples, here we present a comprehensive analysis for one of the samples to illustrate changes at the pore network level. Different techniques were used for the pore-scale analyses, including pore network modeling using PoreStudio, and software developed by the authors to enable a statistical analysis of the pore network. Results provided much insight in how injected carbonated water affects the pore network of carbonate rocks.