Miconia albicans, a common evergreen cerrado species, was studied under field conditions. Leaf gas exchange and pre-dawn leaf water potential (Ψpd) were determined during wet and dry seasons. The potential photosynthetic capacity (PNpmax) and the apparent carboxylation efficiency (ε) dropped in the dry season to 28.0 and 0.7 %, respectively, of the maximum values in the wet season. The relative mesophyll (Lm) and stomatal (Ls) limitations of photosynthesis increased, respectively, from 24 and 44 % in the wet season to 79 and 57 % at the peak of the dry season when mean Ψpd reached -5.2 MPa. After first rains, the PNpmax, ε, and Lm recovered reaching the wet season values, but Ls was maintained high (63 %). The shallow root system growing on stonemason limited by lateral concrete wall to a depth of 0.33 m explained why extreme Ψpd was brought about. Thus M. albicans is able to overcome quickly the strains imposed by severe water stress. and J. A. F. Monteiro, C. H. B. A. Prado.
The characteristics of evapotranspiration estimated by the complementary relationship actual evapotranspiration (CRAE), the advection-aridity (AA), and the modified advection-aridity (MAA) models were investigated in six pairs of rural and urban areas of Japan in order to evaluate the applicability of the three models the urban area. The main results are as follows: 1) The MAA model could apply to estimating the actual evapotranspiration in the urban area. 2) The actual evapotranspirations estimated by the three models were much less in the urban area than in the rural. 3) The difference among the estimated values of evapotranspiration in the urban areas was significant, depending on each model, while the difference among the values in the rural areas was relatively small. 4) All three models underestimated the actual evapotranspiration in the urban areas from humid surfaces where water and green spaces exist. 5) Each model could take the effect of urbanization into account.
Metal stress was induced in maize (Zea mays L.) by the addition to the soil of a range of concentrations of either ethylene-diamine-tetra-acetate (EDTA) or citric acid (CA) as chelating agents. Measurements were taken using a recently-developed sensor capable of plant fluorescence detection at wavelengths of 762 and 688 nm. Atmospheric oxygen absorbs radiation at these wavelengths. As such, measured fluorescence can be attributed to the plants under observation. Red/far-red (690/760 nm, R/FR) chlorophyll (Chl) fluorescence ratios were measured before addition of the chelating agents and during the month following. Significant differences were seen in the fluorescence responses of those plants for which high concentrations [≥ 30 mmol kg-1(d.m. soil)] of EDTA were added to the pots compared to those for which CA or no chelating agent was added. The plants for which high concentrations of EDTA were added also exhibited higher tissue metal concentrations and demonstrated visible signs of stress. Before signs of visual stress became apparent, R/FR Chl fluorescence ratios for metal-stressed plants were significantly different to those observed for unstressed plants. These results support the use of plant fluorescence as a potential tool for early indication of phytotoxic metal stress. and J. J. Colls, D. P. Hall.
This study shows a comprehensive simulation of water and sediment fluxes from the catchment to the reach scale. We describe the application of a modelling cascade in a well researched study catchment through connecting stateof-the-art public domain models in ArcGIS. Three models are used consecutively: (1) the hydrological model SWAT to evaluate water balances, sediment input from fields and tile drains as a function of catchment characteristics; (2) the onedimensional hydraulic model HEC-RAS to depict channel erosion and sedimentation along a 9 km channel onedimensionally; and (3) the two-dimensional hydraulic model AdH for simulating detailed substrate changes in a 230 m long reach section over the course of one year. Model performance for the water fluxes is very good, sediment fluxes and substrate changes are simulated with good agreement to observed data. Improvement of tile drain sediment load, simulation of different substrate deposition events and carrying out data sensitivity tests are suggested as future work. Main advantages that can be deduced from this study are separate representation of field, drain and bank erosion processes; shown adaptability to lowland catchments and transferability to other catchments; usability of the model’s output for habitat assessments.
New type of aerodynamic tilting pad journal bearing was designed and successfully tested in several applications, one of which was power gyroscope support. Bearing design combines advantages of foil bearings, i.e. additional damping achieved by squeezing out gas film and friction of elastic elements on bearing casing surface, with qualities of classical tilting pad bearings, consisting in defined geometry of bearing gap and excellent stability. Theoretical solution of bearing characteristic calculation is shortly described, consisting in numerical solution of gas flow in narrow gap. Some computed data and results of experiments with rotors operated up to 180.000 rpm are presented too. and Obsahuje seznam literatury
The scenario forecasting technique for assessing changes of water balance components of the northern river basins due to possible climate change was developed. Three IPCC global emission scenarios corresponding to different possible scenarios for economic, technological, political and demographic development of the human civilization in the 21st century were chosen for generating climate change projections by an ensemble of 16 General Circulation Models with a high spatial resolution. The projections representing increments of monthly values of meteorological characteristics were used for creating 3-hour meteorological time series up to 2063 for the Northern Dvina River basin, which belongs to the pan-Arctic basin and locates at the north of the European part of Russia. The obtained time series were applied as forcing data to drive the land surface model SWAP to simulate possible changes in the water balance components due to different scenarios of climate change for the Northern Dvina River basin.
This paper describes some results of an experiment aimed at monitoring of contact fatigue during the axial bearings tests. The needful of AE set-up for measuring of signal and Axmat stand for testing is presented here. The measuring of some kind of bearings required the creation of new clamping elements (Segment and Bearing bush) to the existing key point of Axmat stand. The results in this paper show records in the time domain mainly for counts and events. These events are filtered by maximal amplitude for better response on signal changes during the lifetime record. For these evaluated records there are shown the final failures of tested bearings and possible causes of failures beginning. and Obsahuje seznam literatury
The objective of this study was to investigate the relative salt tolerance of four eggplant cultivars (Solanum melongena L.) by studying chlorophyll (Chl) fluorescence parameters during the vegetative growth stage under increasing salinity levels. The plants were grown in pots filled with peat under controlled conditions and were subjected to the salt stress ranging from 0 (control), 20, 40, 80, and 160 mM NaCl for 25 days. The results showed that the increasing NaCl concentration affected hardly the maximum quantum yield of photosystem (PS) II. The quantum yield of PSII (ΦPSII) decreased significantly in ‘Adriatica’ and ‘Black Beauty’ under the salt stress. The photochemical quenching decreased in ‘Black Beauty’ and nonphotochemical quenching increased in ‘Adriatica’ under the salt stress. The Chl fluorescence parameters did not change significantly under the salt stress in ‘Bonica’ and ‘Galine’, revealing their tolerance to salinity. After 25 days of the salt stress, the plant growth was reduced in all cultivars, however, this decline was more pronounced in ‘Adriatica’ and ‘Black Beauty’. Additionally, a significant correlation between the biomass and ΦPSII was observed in ‘Adriatica’ and ‘Black Beauty’. Our results suggest that ΦPSII can be used as a diagnostic tool to identify salt-tolerant egg-plant cultivars., S. Hanachi, M. C. Van Labeke, T. Mehouachi., and Obsahuje bibliografii
A new way of identification of minerals was suggested. The identification was based on chemometric analysis of measured IR spectra of selected minerals. IR spectra were collected using diffuse reflectance technique. The discriminant analysis and principal component analysis were used as chemometric methods. Five statistical models were created for separation and identification of clay minerals. Up to 60 samples of various mineral standards (clay minerals, feldspars, carbonates, sulphates and quartz) from different localities were selected for the creation of statistical models. The results of this study confirm that the discriminant analysis of IR spectra of minerals could provide a powerful tool for mineral identification. Even differentiation of muscovite from illite and identification of mixed structures of illite-smectite were achieved., Michal Ritz, Lenka Vaculíková and Eva Plevová., and Obsahuje bibliografii
Leaf area estimation is an important measurement for comparing plant growth in field and pot experiments. In this study, determination of the leaf area (LA, cm2) in soybean [Glycine max (L.) Merr] involves measurements of leaf parameters such as maximum terminal leaflet length (L, cm), width (W, cm), product of length and width (LW), green leaf dry matter (GLDM) and the total number of green leaflets per plant (TNLP) as independent variables. A two-year study was carried out during 2009 (three cultivars) and 2010 (four cultivars) under field conditions to build a model for estimation of LA across soybean cultivars. Regression analysis of LA vs. L and W revealed several functions that could be used to estimate the area of individual leaflet (LE), trifoliate (T) and total leaf area (TLA). Results showed that the LW-based models were better (highest R 2 and smallest RMSE) than models based on L or W and models that used GLDM and TNLP as independent variables. The proposed linear models are: LE = 0.754 + 0.655 LW, (R2 = 0.98), T = -4.869 + 1.923 LW, (R2 = 0.97), and TLA = 6.876 + 1.813 ΣLW (summed product of L and W terminal leaflets per plant), (R2 = 0.99). The validation of the models based on LW and developed on cv. DPX showed that the correlation between calculated and measured LA was strong. Therefore, the proposed models can estimate accurately and massively the LA in soybeans without the use of expensive instrumentation. and E. Bakhshandeh, B. Kamkar. J. T. Tsialtas