The GNSS (Global Navigation Satellite System) coordinates time series are still used as a source for determining the velocities of GNSS permanent stations. These coordinates, apart from the geodynamical signals, also contain an interference signal. This paper shows the results of the comparative analysis of the GNSS coordinates time series with a deformation of the Earth's crust obtained from loading models. In the analysis, coordinates time series are used (CODE Repro2013) without loading models (Atmospheric Pressure Loading, Hydrology, Non-Tidal Ocean Loading) at the stage of the reprocessing of GNSS archival data. The analyses showed that in the case of the Up component there is a high correlation between the GNSS coordinates changes and deformations of the Earth's crust from the loading models (coefficient 0.5-0.8). Additionally, we noticed that for horizontal components (North, East) changes occur in the phase shift between coordinates, and the Earth’s crust deformations signals are accelerated or delayed each other (-150 to 200 days). This article shows new methods of iLSE (iteration Least Square Estimation) to determine periodic signals in the time series. Additionally, we compared the values of estimated amplitudes for GNSS and deformation time series. and Kaczmarek Adrian, Kontny Bernard.
The GRID_STRAIN software that runs under the MATLAB® environment helped us in achieving the continuous strain field model. Unfortunately, the program averages the results. Therefore, the authors’ main goal of this paper was to work out a method of good verification of data to avoid falsifying of the results of strain calculations. We decided to use the method of the Delaunay triangulation to build a set of triangles of the data (EPN and ASG-EUPOS stations as the vertexes) and by the use of the velocities of each point and their errors, to estimate the single strain in each triangle. This approach made it possible to exclude the outlying values from the data. Selection of the criteria of the characteristic of insufficiently stable points in order to remove them from further computations is of a great importance for the final results of computations of the deformation field. In such a tectonically stable region, as the area of Poland, the strain values should not be higher than 3 to 4 nanostrains/year. At the low rate of tectonic deformations observed in Poland, the disturbances resulting from insufficient stabilization of the ASG-EUPOS network influence the computations of the deformation field to a significant extent. Improper stabilization of a single permanent station causes unification of the deformation field within 2 to 3 computation triangles having a common vertex at this station. Based on this assumption, nearly 30 of the ASG-EUPOS stations were excluded from further strain calculations. The analysis of the geodynamic consistency of the deformation field for the computation triangles is basis for indicating stations for which the dislocation resulting from insufficient stabilization, significantly exceeds the dislocation resulting from the deformation of the lithosphere. Most of the ASG-EUPOS network stations may be used for analysis of local differentiation of the deformation field in Poland., The regularities of the deformations distribution determined by ASG-EUPOS network stations constitute a new set of data which will be used for further geodynamic interpretation. In case of lower rank disturbances resulting from destabilization of the network stations, this factor’s component cannot be recognized using qualitative analysis of the deformation field., Janusz Bogusz, Anna Klos, Mariusz Figurski, Marek Jarosinski and Bernard Kontny., and Obsahuje bibliografii
The paper presents results of epoch satellite GPS and gravimetric measurements performed on the geodynamic network in central part of the Stołowe Mts. between 1993 and 2009. The research results show significant changes of gravity on most of the points and significant horizontal movement of one point in the central part of the area. The results confirm present day activity of the zone where faults Polický, Bělský and Czerwona Woda Fault Zone exists. In addition, they correspond with the studies of seismic activity in this part of the Sudety Mts., Stefan Cacoń, Jan Kapłon, Bernard Kontny, Josef Weigel, Otakar Švábenský and Jiři Kopecký., and Obsahuje bibliografii
We analysed a nearly 133-km-long portion of the Sudetic Marginal Fault (SMF) in Poland (99.7 km) and the Czech Republic (33.8 km), comprised between Złotoryja in the NW and Jesenik in the SE. The fault trace has been subdivided into fifteen segments showing different orientation (N29°W to N56°W, and even N111°W SE of Złoty Stok), geological setting, length (8.8-22.9 km in Poland and 1.4-7.5 km in the Czech Republic), and height of the fault- and fault-line scarps (5-75 m to 200-360 m). Orientation of the entire fault trace approaches N41° W, and the mountain front sinuosity amounts to 1.051. Individual fault segments bear a flight of two to five tiers of triangular facets, showing differentiated state of preservation and degree of erosional remodelling. The highest triangular facets are confined to Rychlebské (Złote) and Sowie Mts. This tiering points to at least five episodes of uplift of the SMF footwall, starting shortly after 31 Ma, i.e. after basalts of the Sichów Hills area were displaced by the fault, and most probably postdating 7-5 Ma time interval, during which rapid cooling and exhumation of the Sowie Góry Mts. massif took place. Morphometric parameters of 244 small catchment areas of streams that dissect the fault scarp include, i.a. elongation, relief, and average slope of individual catchment areas, together with values of the valley flo or width to valley height ratios. These figures point to moderate tectonic activity of the SMF and allow us to conclude about Quaternary uplift, particularly important in the Sowie and Rychlebské (Złote) segments., Janusz Badura, Witold Zuchiewicz, Petra Štěpančiková, Bogusław Przybylski, Bernard Kontny and Stefan Cacoń., and Obsahuje bibliografické odkazy