This paper presents a method for assessing the retention capacity of a floodplain in the course of flooding and for estimating the significance of its water storage for transforming a flood wave. The method is based on two-dimensional numerical modeling of the flood flow in a river channel and in the adjacent floodplains, and is suitable for cases when the morphology of the flooding area is variable and complex, e.g. broad inundation areas with meandering channels. The approach adopted here enables us to quantify the retention capacity for inundation areas of various characters and with various land uses, and provides a tool for estimating the efficiency of possible measures for increasing the water storage capacity of a floodplain. The retention capacity is estimated using an evaluation of a series of detailed flood flow modeling results; the flood wave transformation effect is predicted with the aim of creating a non-linear reservoir model. A parametric study of the floodplain retention capacity for the upper branch of the Lužnice River is presented here, and the results for the current state and for various hypothetical scenarios of changes in geometry and land use are evaluated and compared. and V příspěvku je prezentována metodika pro stanovení retenční kapacity inundačního území při povodňových průtocích a jeho význam pro transformaci povodňové vlny. Metoda využívá dvourozměrný numerický model proudění vody korytem a přilehlým inundačním územím a je vhodná pro případy, kdy charakter nivy je proměnlivý a velmi komplikovaný, např. široká inundační území s meandrujícími toky. Navržený způsob řešení umožňuje kvantifikovat retenční schopnosti niv různého charakteru při různých způsobech využívání a umožňuje případně navrhnout úpravu inundačního území tak, aby transformační účinek při průchodu povodňové vlny byl co největší. Retenční kapacita inundačního území je stanovena na základě výsledků podrobného modelování proudění vody při různých průtokových stavech a transformace povodňové vlny je řešena pomocí iteračního postupu založeného na Bratránkově metodě. V příspěvku je uvedena parametrická studie kvantifikace retenční kapacity nivy na základě vyhodnocení a porovnání transformační schopnosti pro nivu Lužnice v jejím horním úseku pro současný přirozený stav a pro různé teoretické scénáře změněného charakteru a způsobu využívání nivy.
Previous evidence has demonstrated that vertical leaves of Styrax camporum, a woody shrub from the Brazilian savanna, have a higher net photosynthetic rate (PN) compared with horizontal leaves, and that it is detected only if gas exchange is measured with light interception by both leaf surfaces. In the present study, leaf temperature (T leaf), gas exchange and chlorophyll (Chl) a fluorescence with light interception on adaxial and also on abaxial surfaces of vertical and horizontal mature fully-expanded leaves subjected to water deficit (WD) were measured. Similar
gas-exchange and fluorescence values were found when the leaves were measured with light interception on the respective surfaces of horizontal and vertical leaves. WD reduced N values measured with light interception on leaf surfaces of both leaf types, but the effective quantum yield of PSII (ΦPSII) and the apparent electron transport rate (ETR) were reduced only when the leaves were measured with light interception on the adaxial surface. WD did not decrease the maximum quantum yield of PSII (Fv/Fm) or increase T leaf, even at the peak of WD stress. Vertical leaf orientation in S. camporum is not related to leaf heat avoidance. In addition, the similar P N values and the lack of higher values of ΦPSII and ETR in vertical compared with horizontal leaves measured with light interception by each of the leaf surfaces suggests that the vertical leaf position is not related to photoprotection in this species, even when subjected to drought conditions. The exclusion of this photoprotective role could raise the alternative hypothesis that diverse leaf angles sustain whole plant light interception efficiency increased in this species., A. M. Feistler, G. Habermann., and Obsahuje bibliografii
The soil engineer needs to be able to readily identify difficult or problematic soils and to determine the amount of settlement that may occur. This paper deals with the assessment and identification of three types of difficult soils: collapsible soils, swelling soils, and liquefiable soils. In the first instance, the study investigates the effect of some soil properties on wetting-induced collapse strain and the swelling potential of soils. Also, two new methods for predicting soil collapse and swelling potential are developed. The proposed relationships correlate between collapse strain and swelling potential and some soil parameters which are believed to govern soil collapse and swelling. Validation of these two relationships with some data reported in literature is also examined. Furthermore, the paper describes the different steps suggested in a new procedure for soil liquefaction assessment. The procedure was presented in the form of an evaluation guide. In addition, a relationship was suggested for computing the potential for liquefaction. An application of the proposed procedure to a practical case is included in order to validate and illustrate the different steps to be followed in the suggested evaluation procedure.
In this work the performance of Reynolds Averaged Navier-Stokes (RANS) simulations to predict the flow structure developed by the presence of a sidewall obstacle in a uniform open-channel shallow flow is discussed. The tested geometry was selected due to its important role in several fluvial applications, such as the control of riverbank erosion and the creation of improved ecological conditions in river restoration applications. The results are compared against experimental laboratory velocity fields obtained after Large Scale Particle Image Velocimetry (LSPIV) measurements. It is shown that the length of reattachment of the separated shear layer generated by the obstacle is well predicted by a Reynolds Stress Model, while classical two-equation models show important limitations. All the performed RANS simulations are unable to properly predict the formation of a secondary gyre region, which develops immediately downstream the obstacle.
The aim of this study was to investigate the effects of silicon in alleviating cadmium stress in maize plants grown in a nutrient solution and to evaluate the potential of the spectral emission parameters and the ratio of red fluorescence (Fr) to far-red fluorescence (Ffr) in assessing the beneficial effects of Si. An experiment was carried out using a nutrient solution with a toxic dose of Cd and six doses of Si; biomass, Cd, Si, and photosynthetic pigments of the plants were measured. Chlorophyll (Chl) a fluorescence analysis demonstrated that Si alleviated Cd toxicity in plants. Chl fluorescence measurements were sensitive in detecting such effects even when significant changes in biomass production and concentrations of photosynthetic pigments were not observed. The spectral emission and the Fr/Ffr ratio were sensitive to the effects of Si. Silicon caused a reduction in the translocation of Cd to the shoots of maize plants., A. J. Silva, C. W. A. Nascimento, A. S. Gouveia-Neto., and Obsahuje seznam literatury
Isogeometric analysis (IGA) has been recently introduced as a viable alternative to the standard, polynomial-based finite element analysis. One of the fundamental performance issues of the isogeometric analysis is the quadrature of individual components of the discretized governing differential equation. The capability of the isogeometric analysis to easily adopt basis functions implies that high order numerical quadrature schemes must be employed. This may become computationally prohibitive because the evaluation of the high degree basis functions and/or their derivatives at individual integration points is quite demanding. The situation tends to be critical in three-dimensional space where the total number of integration points can increase dramatically. The aim of this paper is to compare computational efficiency of several numerical quadrature concepts which are nowadays available in the isogeometric analysis. Their performance is asessed on the assembly of stifness matrix of B-spline based problems with special geometrical arrangement allowing to determine minimum number of integration points leading to exact results. and Článek zahrnuje seznam literatury a na str. 257-259 Appendix
Empirical formulae are often used in practice to quickly and cheaply determine the hydraulic conductivity of soil. Numerous relations based on dimensional analysis and experimental measurements have been published for the determination of hydraulic conductivity since the end of 19th century. In this paper, 20 available empirical formulae are listed, converted and re-arranged into SI units. Experimental research was carried out concerning hydraulic conductivity for three glass bead size (diameters 0.2 mm, 0.5 mm and 1.0 mm) and variable porosity. The series of experiments consisted of 177 separate tests conducted in order to obtain relevant statistical sets. The validity of various published porosity functions and empirical formulae was verified with the use of the experimental data obtained from the glass beads. The best fit was provided by the porosity function n3/(1–n)2. In the case of the estimation of the hydraulic conductivity of uniform glass beads, the best fit was exhibited by formulae published by Terzaghi, Kozeny, Carman, Zunker and Chapuis et al.
Based on the examination and quantitative comparison of the approaches used to assess the energy partitioning in photosystem II, the unified method was proposed to calculate the contribution of the components of nonphotochemical quenching. and D. Kornyeyev, C. R. Guadagno, N. D’Ambrosio.
In the marketing area, new trends are emerging, as customers are not only interested in the quality of the products or delivered services, but also in a stimulating shopping experience. Creating and influencing customers' experiences has become a valuable differentiation strategy for retailers. Therefore, understanding and assessing the customers' emotional response in relation to products/services represents an important asset. The purpose of this paper consists of investigating whether the customer's facial expressions shown during product appreciation are positive or negative and also which types of emotions are related to product appreciation. We collected a database of emotional facial expressions, by presenting a set of forty product related pictures to a number of test subjects. Next, we analysed the obtained facial expressions, by extracting both geometric and appearance features. Furthermore, we modeled them both in an unsupervised and supervised manner. Clustering techniques proved to be efficient at differentiating between positive and negative facial expressions in 78\% of the cases. Next, we performed more refined analysis of the different types of emotions, by employing different classification methods and we achieved 84\% accuracy for seven emotional classes and 95\% for the positive vs. negative.