Introduction: Ankylosing spondylitis (AS) is an inflammatory rheumatic disease characterized by the development of osteoproductive changes in the spine which could possibly result in ankylosis. Treatment with tumour necrosis factor alpha (TNFα) inhibitors has proved to be an important step forward in the treatment of this disease, but for the time being it is not clear whether it favourably influences radiographic progression of the disease. Vascular endothelial growth factor most probably plays a role in the development of osteoproductive changes and recently its predictive influence on radiographic progression has been demonstrated. Bone morphogenic protein 2 (BMP-2) participates in the regulation of bone proliferation and its increased serum level has been demonstrated in patients with advanced AS and correlated with the degree of radiographic changes. Aim: The study aims to evaluate the VEGF and BMP-2 levels in patients with ankylosing spondylitis and how these levels relate to the concurrent treatment with TNFα inhibitors. Methods: Sera were evaluated from patients at the Rheumatologic Clinic of the Hradec Králové Faculty Hospital who fulfilled the modified New York Criteria for AS (n = 55). In these patients, the parameters of the activity of the disease (BASDAI = Bath Ankylosing Spondylitis Disease Activity Index, CRP = C-reactive protein) and the concurrent therapy (TNFα inhibitors, n = 21, vs. non-anti TNFα, n = 34) were recorded. The levels of VEGF and BMP-2 were analyzed using the ELISA method. Results: In patients treated with TNFα inhibitors, a significantly lower VEGF level was found when compared to untreated patients (140.3 (109.4; 262.2) vs. 261 (172.4; 396.6) pg/ml; p = 0.02). No difference was found between BMP-2 levels in both groups (treated vs. untreated patients) (254.8 (2301; 267.3) vs. 261.1 (248.6; 273.5) pg/ml; p = 0.24). A correlation analysis did not reveal any relationship between VEG F and BMP-2 (r = 0.057; p = 0.68). Serum levels of VEGF correlated with serum levels of CRP (r = 0.56; p = 0.00001) and the BASDAI value (r = 0.33; p = 0.015). Conclusion: Significantly lower VEGF levels were found in patients treated with TNFα inhibitors versus the untreated patients. These findings are in harmony with some hitherto published analyses and may give evidence of a favourable effect of TNFα inhibitors on radiographic progression. Neither influence on the BMP-2 level by treatment with TNFα inhibitors nor correlation with VEGF levels was demonstrated. and M. Tošovský, P. Bradna, C. Andrýs, K. Andrýsová, E. Čermáková, T. Soukup
BACKGROUND: The current treatment of hereditary hemochromatosis (HH) consists of performing periodic whole blood phlebotomies. Erythrocytapheresis (EA) can remove up to three times more red blood cells per single procedure and could thus have a clinical benefit. A prospective study of 30 consecutive cases of HH were included in a periodic EA program. METHODS AND PATIENTS: EA were performed using a discontinuous flow cell separators. The protocol consisted of a bimonthly EA until normalization of the serum ferritin was reached. The aim was to reduce the total erythrocyte volume by 25-35%, eventually, to adjust the amount so that hematocrit would not drop below 0.25. RESULTS: 530 +/- 101 ml of erythrocytes were removed (median 517, range 116-761 ml). Iron depletion (ferritin < 20 microg/l) was achieved in all patients after a mean 6.9 +/- 7.6 months, median 5 months, range 1-36 months and a mean 14 EA sessions. The procedures were well tolerated and there were no severe side-effects. CONCLUSIONS: We conclude that HH patients treated with EA achieved iron depletion quickly under good conditions of tolerance. The efficacy, speed, tolerability, and more favorable schedule of an EA program facilitate treatment of HH. and V. Rehácek, M. Bláha, H. Jirousová, J. Cernohorská, P. Papousek
INTRODUCTION: The aim of this study was to find out the impact of degradation and regeneration of force over time at NiTi springs on the value and course of the final acting force and to verify the possibility of using these phenomena for a directed transition to the reverse plateau and its maintaining. METHODS: Static and cyclic mechanical loadings were performed. At first unused springs were tested. Afterwards the springs were mechanically stabilized by stress cycling and finally tested again. The difference in shape of the working curves was assessed. For simulation and description of the force degradation the modified Voight model was used. RESULTS: New springs, mainly those with large hysteresis, showed a significant stress-strain curve movement and shape changes during the cycling. The effect of the stress-strain curve course change disappeared fully in the stabilized springs. Multiple loading led to an overall decrease of force value during the measurement. The effect of force degradation and regeneration over time by simple static loading varies in the range of percentage of the nominal force in the plateau area. The transition between stress-strain curve phases caused by the degradation or regeneration of the force wasn't observed in case of mechanically stabilized springs. CONCLUSIONS: Springs should be mechanically stabilized before their application. The degree of force degradation over time is insignificant for mechanically stabilized springs. Degradation or regeneration of force over time, mechanical stabilization or micromovements in the mouth don't cause any transition between individual stress-strain curve phases. and A. Bezrouk, L. Balský, M. Smutný, T. Nosek, J. Záhora, J. Hanus, R. Polma