The paper presents the preliminary results of the analysis of two archival SAR datasets acquired by ERS-1/2 satellites of the same area of Roznow Lake in Southern Poland. Both datasets cover the same period of 8 years (1992 - 2000) and refers to the same area by the 50% of overlap between the neighbouring satellite tracks. The main purpose of this analysis was to derive the overlapping data about deformation velocity calculated using PSI (Persistent Scatterers Interferometry). The presented PSI results refer to PS (Persistent Scatterers) located on active landslides and therefore representing landslide movement. In Polish Carpathians, due to sparse urbanization, vegetation and rough relief the obtained PS density is usually not very high and generally difficult to interpret. The application of two overlapping datasets, where both of them observe the same phenomena, allow to cross-validate the data by identification of common PS points. For two datasets acquired from different tracks, usually many PS are not common and occur at different locations. Such situation could be explained by the difference between the incidence angles for both acquisitions. In a case of two tracks and therefore different terrain objects might act as PS. By joining the PS point sets from such neighbouring tracks the density of PS could be significantly increased. In order to perform a PSI analysis of Roznow Lake the data acquired from 179 and 408 tracks have been used and a few hundred of PS were obtained from PSI processing. For both tracks similar deformations velocity were obtained within a range of +/- 6 mm/yr. The PS points on active landslides are usually related to the buildings (walls, roofs) and roads affected usually by high risk., Zbigniew Perski, Andrzej Borkowski, Tomasz Wojciechowski and Antoni Wójcik., and Obsahuje bibliografii
This paper presents the results of geophysical survey performed in the Pilawa River valley in the area of Middle Pomerania (Poland). The resistivity imaging method was applied. Resistivity profile measuring eight hundred metres allowed to investigate the geologic structure to the depth of 150 metres. The resistivity cross section shows the structure of Pleistocene sediments and the depth of Miocene - Pleistocene boundary. The significant lowering of the boundary is related to assumable ice-sheet margin range of Pomeranian phase of North Polish Glaciation. The lowering of the boundary may be a result of sediments compaction and the subglacial tunnel slope as well., Bogdan Żogała, Ryszard Dubiel, Józef Lewandowski, Waclaw M. Zuberek and Grzegorz Gąska., and Obsahuje bibliografické odkazy
Depletion of exploited mineral ore resources and their constant price increase have contributed to active interest in recognition and exploitation of new workable deposits. Exploration work which has been carried out in the vicinity of non-exploited ore areas such as Klucze, Zawiercie and Laski results in confirmation of Zn-Pb commercial deposits. In this region Zn-Pb ores occur in the Devonian and Triassic carbonate formation at a depth of 70 - 80 metres under the surface. Geological recognition is based on the analysis of data taken from bore-holes. To determine the mode of the ores occurrence and service conditions, it is necessity to work out a spatial image of overburden structure. For this reason resistivity measurements with highly distributed LUND Imaging System were introduced in the area of Zawiercie I. The studies were carried out according to three measuring protocols: Schlumberger, Wenner and dipole-dipole. The measurements were performed along three parallel six-hundred-metre profiles. The resistivity cross sections were elaborated using Res2D software. The results of the geophysical research were correlated with the data taken from bore-holes in order to testing the efficiency of applied geoelectrical methods. The study showed a significant diversification of geoelectric characteristics of the rockmass and thus it allowed to recognise accurately the overburden structure of the deposit and to locate precisely zones of faulting. In future, the applied geoelectrical methods are certainly to be used for localization ore bodies at a considarable depth range., Krzysztof Jochymczyk, Jerzy Cabala and Artur Poreba., and Obsahuje bibliografii
This research evaluates the potential benefits of the tightly combined processing of a global navigation satellite system together with the additional ranging observations from a satellite based augmentation system. In specific, the experiment presents performance of precise instantaneous single-frequency positioning based on European Galileo and EGNOS navigation systems. Due to currently low number of Galileo satellites, the test observational data were obtained with hardware GNSS signal simulator. All calculations were performed with in-house developed software - GINPOS. The results show that it is possible to obtain improvement in the accuracy and reliability of single-frequency precise positioning when including observations from SBAS systems. However, one must take in to account that at middle latitudes EGNOS satellites are observed at low elevations what results in higher atmospheric errors affecting its signals., Jacek Paziewski, Paweł Wielgosz and Marta Krukowksa., and Obsahuje bibliografické odkazy
Oil derivatives contamination of soils effects in changes of many physical properties of soil su ch as: electrical resistivity, conductivity and self potential (SP) as well. Thus the measurable a nomalies of these properties are possible to detect with geoelectrical measurements. SP geoelectrical measurements were carried out in the area of controlled oil spill. The oil was spilled into vadose zone of dry sands. The first underground water level was observed at the depth of 10 m. The measurements were carried out along 20 m long profile situated above 3 m long contaminated zone. The part of contaminated zone (1.5 m) had been subjected to bioremediation process with yeasts Yarrowia lipolytica since 4 months. In the border of contaminated zone and biodegradate done chemical gradient was developed and significant in crease of self potentials values can be observed. The measurements were carried out with potential gradient method. L und Imaging System equipment and non-polarizable electrodes (Cu/CuSO 4 ) were applied. Above contaminated and biodegraded zone distinct SP anomaly (10-20 mV) was measured. The anomaly correlates with results of EM, resistivity imaging and induced polarization investigations., Bogdan Żogała, Maciej J. Mendecki, Wacław M. Zuberek and Małgorzata Robak., and Obsahuje bibliografické odkazy
The paper presents the results of research related to the application of GNSS solutions in short observational periods in geodynamical investigations. Authors used the 3-hour solution appointed from hour-long interval of about 30 chosen stations on mountainous terrains from over 100 which were worked out. The main aim was to check the correctness of such solutions by the comparison with the daily ones. Some outliers in East component could testify, that tropospheric or ionospheric models used in the data adjustment are not sufficient for so short-time solutions. The second principal problem, which was considered in the present work is the ability to detect diurnal and sub-diurnal oscillations in changes of permanent stations’ coordinates. Results show unambiguously, that such oscillations appear in all analysed stations. In the paper there are examples of stations with dominant oscillations in different frequencies. The clear homogeneous in the frequencies was not found among any group of stations. It is therefore difficult to affirm, if their origin comes purely from the geodynamical phenomena., Andrzej Araszkiewicz, Janusz Bogusz, Mariusz Figurski and Karolina Szafranek., and Obsahuje bibliografii
The use of Continuously Operating Reference Stations, both singly and as part of an active network, is widely employed in surveying, engineering and other geomatics applications, achieving high accuracy positioning even in real time. With an active network the measurements of the reference stations are processed jointly in order to model the errors and compute network RTK corrections. Due to distance dependent errors (ionospheric and tropospheric delays), single base RTK positioning accuracy decreases with increased baseline length. However, the network solution (NRTK) retains the accuracy and the time to fix ambiguities (TTFA) at a constant level. This study aims to contribute to the scientific research on real time positioning based on active networks. In Southern Spain, ERGNSS, a national CORS network that provides GNSS data for post-processing and real time single- b ased reference station corrections, shares territory with the Andalusian Positioning Network (RAP), a local active network. RAP provides network an d single-based RTK corrections. In order to analyze the quality of real time positioning based on both networks, several tests have been performed on a sample of test points. The reference frame, the time to fix ambiguity resolution, precision, accuracy and repeatability of RTK positioning are considered as the evaluation parameters. The results confirm that the RAP network complements the precise positioning services provided by the ERGNSS network, ensuring accurate real time positioning, full cove rage and reliable positioning services in the Andalusian Community., Mª Selmira Garrido, Antonio J. Gil and Rafael Gaitán., and Obsahuje bibliografické odkazy
Samples of bottom ash and fly ash coming from the combustion of lignite with the addition of limestone, from the cocombustion of lignite and wood residue with limestone and from co-combustion of lignite, wood residue, biological sludges from the waste water treatment plant and municipal waste as well with the addition of limestone were examined. Scanning electron microscopy with X-ray microanalyser were used for study of morphology and chemical composition of ash particles. The results were compared with average composition of bottom ashes, fly ashes and input materials found by X-ray fluorescence spectrometry and with phase composition found by X-ray diffraction method. There were proved no significant differences in the character and the structure of individual samples coming from various regimes of combustion., Vladimír Tomášek, Ondřej Šustai, Jana Seidlerová, Zdeněk Klika, Martin Stach, Zdeněk Weiss and Václav Roubíček., and Obsahuje bibliografii
While including gradual long-term flooding of individual residual mining pits, the re-vitalization program of the Podkrušnohorská brown-coal basin area has to assure - beside general water quality standards - satisfactory stability level of future lake banks and their wider environment as required for safe usage of future water lakes. General assessment of factors and conditions influencing bank and/or slope stability of future lakes was realized within the frames of the Czech Republic Academy of Sciences grant project. The grant project solutions include a study of exogenous processes on localities where the mining has been terminated. Also, prognoses were developed on behaviour of future banks during flooding and subsequent operation of future lakes. The presented paper is focused on assessment of mayor factors that participate on initiation and intensity of the bank abrasion and sliding deformations., Tamara Spanilá, Zdeněk Kudrna, Vladislav John, Filip Hartvich and Vladimír Chour., and Obsahuje bibliografické odkazy
A method for estimation of elastic wave velocity anisotropy based on ultrasonic sounding data during rock-sample loading was developed. The subject matter of the method is approximation of ultrasonic sounding data by triaxial velocity ellipsoid. The applicability of proposed method was verified on investigation of anisot ropic rock samples. Laboratory loading of migmatite samples was realized under various mutual orientations between acting force direction and rock foliation - perpendicular, parallel and under 45°. P-ve velocity of ultrasound waves was monitored by 8 sensors network. The velocity ellipsoid was computed and changes of sizes and waorientation its main axes during loading were analyzed for separate experiments with regard to loading level. It was found, that independently to mutual orientation between rock foliation and loading direction, the minimum velocity vector turns to perpendicular direction to final rupture plane and maximum velocity vector turns to the plane of final rupture., Matěj Petružálek, Jan Vilhelm, Tomáš Lokajíček and Vladimír Rudajev., and Obsahuje bibliografické odkazy