The aim of the AIRFLY (air fluorescence yield) project is to simulate and to measure the process of the fluorescence and Cherenkov emission produced by impact of cosmic rays on molecules of nitrogen in high level atmosphere. Several setups were designed to measure fluorescent and Cherenkov light. In this paper we report the chamber with controlled atmosphere to simulate conditions in various levels of the Earth atmosphere. The chamber was designed in the Institute of Physics of Academy of Sciences of the Czech Republic in cooperation with the Faculty of Mechanical Engineering, Czech Technical University and the Joint Laboratory of Optics of Palacky University and Institute of Physics of Academy of Sciences in Olomouc. and Cílem projektu AIRFLY je napodobit a proměřit proces fluorescenční a Čerenkovské emise vznikající dopadem kosmického záření na molekuly dusíku ve vyšších vrstvách atmosféry. Bylo navrženo několik uspořádání pro měření fluorescenčního a Čerenkovského světla. V tomto článku je popsána komora s řízenou atmosférou pro modelování podmínek v různých výškách zemské atmosféry. Komora byla zkonstruována ve Fyzikálním ústavu AV ČR ve spolupráci se Strojní fakultou ČVUT a Společnou laboratoří optiky Univerzity Palackého a FZÚ AV ČR v Olomouci.
The fluorescence detector array of single-pixel telescopes is a low-cost, large-area, next-generation experiment for the detection of ultrahigh-energy cosmic rays via the atmospheric fluorescence technique. The proposed design involves the deployment of several hundred large field-of-view fluorescence telescopes on a regular grid of several thousand square kilometres in ground area. This paper describes the optical design of the telescope, as well as its mechanical support structure. and Pole fluorescenčních detektorů složené z jednopixelových teleskopů představuje levný experiment nové generace observatoří pro detekci vysokoenergetického kosmického záření snímaného na velké rozloze za použití fluorescence sekundárního záření v atmosféře. Předkládaný projekt počítá s několika sty fluorescenčních teleskopů umístěných v pravidelné síti na ploše několika tisíc čtverečných kilometrů. Příspěvek popisuje optický návrh teleskopu a také podpůrnou mechanickou konstrukci teleskopu.
The paper gives the comparison of results of total joint artificiant wear measurement with simulation carried out using the knowledge of its mechanical wear. The used methods are the 3D scaning profilometry topografie and Fourier profilometry. The results are compared with the latest used measurement method - gravimetry. The uncertainties of methods are not introduced in text but only the primary results of measurements, which are the basic of methodology of verification of possibility of application of these methods for the given purpose.