In the contribution geological structure and geophysical data along the northern part of the Diendorf-Čebín tectonic zone (DCTZ) is analyzed in relation to the position of the measured GPS test areas and precise levelling profiles. For this purposes the former geophysical data have been reambulated and analyzed, too. Revision of geological knowledge and sources has been done in places of the proposed polygons. The results of reinterpretation of the Grav/Mag data and selected seismic reflection profiles suggest new possibilities and variety of structural interpretations of this tectonic zone. It is evident that the whole tectonic system has undergone complicated tectonic development during the Paleogene and Neogene. Therefore the recent mapping and analyses by GPS and precise levelling have to be realized in places where the geological structural ambiguity has to be eliminated., Lubomil Pospíšil, Otakar Švábenský, Josef Weigel and Michal Witiska., and Obsahuje bibliografii
The research is focused on the feasibility analysis of a numerical model describing the field of strains generated by mining-induced subsidence caused by a deep underground coal extraction, which may contribute to the formation of Earth fissures. The finite elements method and Knothe’s theory were used in the research. The geomechanical modeling was applied for defining zones of strains and maximum horizontal deformations of the terrain. Knothe’s theory was employed for defining boundary conditions of the geomechanical model. The parameters of the empirical and geomechanical models were scaled out on the basis of geodetic surveys in the mining area. The results of geomechanical modeling were compared with the geodetic surveys to select the best model. The presented research confirmed high congruence between the results of modeling with the finite elements method and observations of vertical movements on the surface. The results of modeling also confirmed the assumed highest stress in areas where earth fissures were observed. The proposed solution may be a new research tool applicable to areas where earth fissures potentially occur. and Malinowska Agnieszka A., Misa Rafał, Tajduś Krzysztof.
Four precise leveling campaigns has been carried out in Poland, and for several years there is a functioning system of permanent GNSS stations determining the height of network points. On the basis of these data, several variants of vertical crustal movements models have been developed (Wyrzykowski, 1987; Kowalczyk, 2005; Kontny and Bogusz, 2012). In order to develop a kinematic model of vertical crustal movements, one of the possibilities is an adjustment of the network formed simultaneously with the leveling data and GNSS stations data. The main problem is a need to identify fiducial points between the datasets. This problem can be solved by creation of coherent database containing attributes of both types of data and automatization of the joint point identification process. The article shows the results of such identification process, depending on the amount of data, on the example of the area of Poland. and Bednarczyk Michal, Kowalczyk Kamil, Kowalczyk Anna.
The aim of the study is to identify the recent local geodynamic processes on the territory of the Dniester PSPP (Ukraine), which arose as a result of the additional man-caused load during the construction of hydro-technical structures. The research is based on the results of 17 cycles of periodic static GNSS campaigns conducted during 2004-2017. In this work the vectors of horizontal displacement of the reference GNSS network points of Dniester PSPP are determined and their scheme is constructed. On the basis of average vectors of horizontal movement velocities during 2004-2017, the value of the velocities of dilatation - the parameter of Earth surface deformation which characterises the relative area expansion or compression, is calculated. As a result of the analysis of velocity distribution of the dilatation of Dniester PSPP territory, the areas of extreme values of compression and stretching are revealed, which testify to the increased geodynamic activity of the pivot part, as well as the main structures of the construction. and Savchyn Ihor, Vaskovets Serhii.
The paper studies the connection between the X-ray and thermo quartz luminescence, the massif formation facie features and differentiation of magmatic melt features, using the example of the Permian-Triassic granitoids from the Kolyvan-Tomsk folded belt (KTFB; the Kolyvan, the Barlak, the Ob, and the Novosibirsk rock massifs). The X-ray luminescence optical spectra and the thermoluminescence curves of quartz from the massifs listed above are obtained. The quartz luminescence is proven to be linked to the features of the magmatic melt differentiation. It is shown that the equivalence of the X-ray- and the thermoluminescence of granitoids quartz from different massifs are the result of similar conditions and mechanisms of the granitoids formation with close establishment periods. The obtained data make it possible to consider the KTFB granitoid magmatism as a result of natural magmatic differentiation of the original magma and to use the quartz emission spectra for typing granitoid massifs. The individuality of the Novosibirsk massif quartz, manifested in intense luminescence of Fe 3+, defects of O * (370 nm) and thermoluminescence (TL) at 180-220 °C, can be associated with high fugacity of oxygen, increased temperature and rate of mineral formation in rock collapse mode under tectonically active zone conditions. At the same time, the obtained data provides evidence for the differences in the leucocratic magmatism of the area, allowing differentiation of the Kolyvan-Tomsk folded belt leucogranites into the leucogranites of the Novosibirsk massif (Mo-W type of mineralization) and the leucogranites of the Kolyvan and the Barlak massifs characterized by rare metal mineralization (stannic-tungstic-beryllic with silver). and Boroznovskaya Nina Nikolayevna, Nebera Tatyana Stepanovna.
The paper presents the results of fieldwork and geodetic surveys carried out on a landslide in Wleń (Western Sudetes, Izerskie Foothills). This reactivated landslide occured firstly in 2011 and later on 16th July 2016, following heavy rainfall in the Lower Silesia region, and covered an area of ca. 1100 m2 above the renovated “Leśny Dwór” guesthouse in Wleń town. The main scarp of the landslide is built of strongly deformed Upper Permian (Zechstein) heterolithic deposits, composing the marginal part of the Wleń Graben - a NW-SE elongated, tectonic sub-unit within the North Sudetic Synclinorium. The landslide was a consequence of undercutting of steep slopes of the Bóbr River valley by anthropogenic activities and loading of the slope surface by blocks and pedestrian paths in the vicinity of the guesthouse. Monitoring of landslide activity was performed using the initial surface model of the slope subjected to mass movements, LiDAR elevation data, as well as 3D point cloud data from a non-metric camera on an Unmanned Aerial Vehicle (UAV). They were used to construct digital elevation models (DEMs) of the area covered by the landslide. The DEM from photogrammetric UAV data was processed using Structure from Motion (SfM) technology. The obtained dataset was verified by additional measurement series from terrestrial laser scanning (TLS). and Kowalski Aleksander, Wajs Jaroslaw, Kasza Damian.
The GRACE satellites have provided gravity field solutions with approximately monthly resolution since April 2002. The monthly solutions enable investigations of the annual, semi-annual and secular mass variations, which mainly occur in a thin layer of the Earth’s surface. By the end of the GRACE science mission in 2017, the time span has increased to 15 years, making the possibility of determining longer-period variations feasible. First attempts to determine multi-annual variations, i.e. periods of some years but less than 10, are presented in this study. A combination of 3 different PSD estimation methods has been used for identifying the regions of multi-annual mass variations. As a result, 8 different areas have been found with significant multi-annual mass variations. The source of multi-annual mass variations in most detected regions can be identified as related to the ENSO cycle. and Kiss Annamária, Földváry Lóránt.
The fault displacement monitoring network EU-TecNet was established to define microdisplacements across faults in the territory of Central Europe (www.tecnet.cz) using three-dimensional optical-mechanical extensometers. The results of long-term neotectonic activity obtained from two caves localized in the eastern part of the Slovenský kras Mts. (SE Slovakia) show generally NE-SW oriented dilatation. This orientation is in a good accordance with the orogen-parallel extension monitored in the Western Carpathians. Differing short-lasting trends were distinguished in 2011-2012 and 2013-2015, which supports the significance of the tectonic pulse at the end of 2012 and the beginning of 2013. Moreover, simultaneous short-lasting faulting occurred at both sites under the transtensional tectonic regime, where the principal maximum compressional axis operated in a NW-SE direction (σ1). The observed results were compared to data from monitoring points in distant areas of the European plate. and Briestenský Miloš, Hochmuth Zdenko, Littva Juraj, Hók Jozef, Dobrovič Roman, Stemberk Josef, Petro Ľubomír, Bella Pavel.
Ultrasonic velocity anisotropy in the rock provides information of variability of the dynamic elastic moduli. Young’s modulus and Poisson’s ratio calculated from waves velocities can be used to determine brittleness index, which is usually used to predict rock susceptibility for hydraulic fracturing. This paper describes laboratory ultrasonic measurements carried out in order to improve hydraulic fracturing designing. The research was conducted over two types of rock: shale and limestone. The samples were cut out perpendicularly and parallel to the bedding planes. Next they were tested for effective porosity and mineral composition using XRD method. Directionally depended seismic velocities revealed noticeable anisotropy of laminated shale, caused by orientation of the bedding planes and weak anisotropy of limestone. Based on the velocities, dynamic elastic moduli and its anisotropy coefficients were determined. Calculations of brittleness index based on Young’s modulus to Poisson’s ratio relation and three types of mineral composition brittleness indexes, revealed strong variability in brittleness for both kind of tested formations. These results show, that different types of brittleness indexes should be used complementary, to better describe fracability of the rock. and Moska Rafal, Kasza Piotr, Maslowski Mateusz.
Bosnia’s seismotectonics seems to follow the Mediterranean marine regime. Earthquakes occur mostly in the outer Dinaric Alps (southern Bosnia), while the strongest earthquakes occur within the Sarajevo Fault system in southern and northwestern Bosnia. In addition to active tectonics being strong, crustal earthquakes occur often as well. Due to Bosnia’s rich hydrogeology, crustal loading such as by snow and rain, or reservoir inundation, represents the most important secondary seismogenic source in the region. Despite its exquisite and active geomorphology no comprehensive and reliable geodynamical studies exist on the region. Seismic sensors coverage is extremely poor also. One centenary analogue, and a few recently installed digital seismometers are insufficient for a region that exhibits mild-to-high seismic activity. Significant investments are needed in order for GPS, seismic and other sensor-instrumented networks to be put in place or enhanced. Technical personnel needs to be educated to enable support provide for studies that are done within broader scientific activities. Such efforts that presently seek to include Bosnia under their scope are ESF-COST Action 625, NATO Stability Pact DPPI program, and EUREF/CERGOP geophysics projects., Mensur Omerbashich and Galiba Sijarić., and Obsahuje bibliografii